Results 171 to 180 of 296
Thread: SEPA Milling Party?
-
February 5th, 2020, 10:46 PM #171
Re: SEPA Milling Party?
Not bad, we had one err, which affects cosmetics only where the end mill went a little deeper in one spot. Here's a look at it.
Milled lower 1.JPGGender confusion is a mental illness
-
February 5th, 2020, 10:59 PM #172
-
February 6th, 2020, 10:06 AM #173
-
February 6th, 2020, 10:08 AM #174
Re: SEPA Milling Party?
Did you assemble it after you completed the milling?
Join the GOA & save $5.00. https://www.gunowners.org/mac-subs-join-goa.htm
-
February 6th, 2020, 10:14 AM #175
Re: SEPA Milling Party?
No, not on site, I'll have to check and see if he did later. The pieces fit in there but clearances were pretty tight, tighter than I think they should be. For some reason (not because I really know) I think there should be a little wiggle room to allow for dust, maybe anodizing and expansion when it gets warm. It was close though, and he wanted to finish it by hand. I figure he did not want to mill too much material away with the machine.
Gender confusion is a mental illness
-
February 6th, 2020, 10:18 AM #176
Re: SEPA Milling Party?
If no one is going to jump in, I will offer up my block as the next sacrificial piece.
But I'm in no hurry, and I am happy to sit and watch.How can you have any cookies if you don't drink your milk?
-
February 6th, 2020, 10:23 AM #177
-
February 6th, 2020, 10:28 AM #178
-
February 6th, 2020, 10:49 AM #179
-
February 6th, 2020, 10:54 AM #180
Re: SEPA Milling Party?
Well I am around most day's now once my kids get on the bus and I know Bern is as well if you guy's want to set up a date and time in the next week or two during the week.
What Jig are you using?Last edited by Hodgie; February 6th, 2020 at 10:59 AM.
Join the GOA & save $5.00. https://www.gunowners.org/mac-subs-join-goa.htm
Similar Threads
-
Anyone want to have a milling party for their 80% receivers..
By edstephan in forum RiflesReplies: 24Last Post: January 26th, 2020, 04:03 PM -
AR milling jig
By jbraun948 in forum GunsmithingReplies: 0Last Post: March 10th, 2014, 03:32 AM -
Custom milling on my M&P Pro
By garyaug in forum PistolsReplies: 11Last Post: August 28th, 2013, 09:42 PM -
Hk USC/ump milling
By BIRTHMACHINE in forum GeneralReplies: 3Last Post: December 10th, 2009, 09:18 AM
Bookmarks