Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 10 of 14

Thread: Poly lower saves a pound

Thread Tools
Display
- Switch to Linear Mode
- Switch to Hybrid Mode
- Threaded Mode

Threaded View

October 31st, 2019, 11:58 AM #1
Bang

View Profile

View Forum Posts

Private Message

Grand Member
Join Date

Feb 2010

Location

Levittown, Pennsylvania
(Bucks County)

Posts

9,655

Rep Power

21474860
Poly lower saves a pound

A few years ago I bought a New Frontier complete lower. It was for a Bushmaster dedicated .22LR upper that turned out to be a bad design that was a pia to operate which I gave up on. The New Frontier lower has been stashed in a parts box. Yesterday I got it out thinking about maybe eventually putting something together.

I removed a DPMS lower from a Frankencarbine and noted the New Frontier latched up nice and snug. Out of curiosity I weighed the DPMS lower and then the New Frontier. The New Frontier weighed 17 ounces lighter than the aluminum DPMS. Thought I'd post in case anyone has been thinking about a poly lower for weight savings.

Last edited by Bang; October 31st, 2019 at 12:31 PM.

There are two kinds of guns. Those I have acquired, and those I hope to.

Reply With Quote