Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 2 of 2

Thread: Good Job MEC

Thread Tools
Display
- Switch to Linear Mode
- Switch to Hybrid Mode
- Threaded Mode

Threaded View

June 28th, 2019, 01:18 PM #1
Grizz2720

View Profile

View Forum Posts

Private Message

Super Member
Join Date

Apr 2008

Location

Frozen tundra, Wisconsin

Posts

688

Rep Power

7019175
Good Job MEC

I bought a MEC 12 ga Sizemaster for reloading almost 20 yrs ago. After reloading 11,000 rounds of 12 ga. The sizing die quit working.
Now I live about 5 miles from the MEC customer service center. I took my Sizemaster over to the service center and less than 24 hrs latter it was fixed, cleaned, lubed up, and ready for me to pick up. A roller asm that works the sizing die stripped out and came off.
Great Job MEC.

I always stressed to my son"one shot one kill that was all that is needed". When He came home from Marine Corp Boot camp He was telling me about the Marines stressing "ONE SHOT ONE KILL" He looks at me and the light bulb went on Dad was now a whole lot smarter than he was 13 weeks ago.

Reply With Quote