Results 1 to 2 of 2
Thread: Using Dremel for Clearance
-
December 13th, 2018, 08:22 AM #1
Using Dremel for Clearance
Have a PSA pistol upper with M Lok HG. Want to install M Lok hand stop. Gas block interferes. Have shortened M Lok screws. Exposed gas block set screws still interfere. Any harm in cutting off/ grinding down exposed set screws on gas block...then cold blueing them for rust protection?
A Republic, if you can keep it.
-
December 13th, 2018, 09:19 AM #2
Re: Using Dremel for Clearance
I don't see an issue with that. The exposed threads are useless.
Similar Threads
-
Genin got a dremel.
By Genin in forum Gun PicturesReplies: 22Last Post: November 13th, 2012, 03:06 PM -
M&P40 after a quick dremel job
By bripro in forum Gun PicturesReplies: 14Last Post: July 20th, 2010, 09:46 AM -
The Dremel Thread!
By Atomic Dog in forum GeneralReplies: 24Last Post: September 30th, 2008, 07:02 AM
Bookmarks