Pennsylvania Firearm Owners Association
Results 1 to 2 of 2
  1. #1
    Join Date
    Feb 2009
    Location
    Between Heaven and Hell, Pennsylvania
    (Berks County)
    Age
    57
    Posts
    1,485
    Rep Power
    21474848

    Default Using Dremel for Clearance

    Have a PSA pistol upper with M Lok HG. Want to install M Lok hand stop. Gas block interferes. Have shortened M Lok screws. Exposed gas block set screws still interfere. Any harm in cutting off/ grinding down exposed set screws on gas block...then cold blueing them for rust protection?
    A Republic, if you can keep it.

  2. #2
    Join Date
    Jun 2010
    Location
    Wynnewood, Pennsylvania
    (Montgomery County)
    Posts
    262
    Rep Power
    2476993

    Default Re: Using Dremel for Clearance

    I don't see an issue with that. The exposed threads are useless.

Similar Threads

  1. Genin got a dremel.
    By Genin in forum Gun Pictures
    Replies: 22
    Last Post: November 13th, 2012, 03:06 PM
  2. M&P40 after a quick dremel job
    By bripro in forum Gun Pictures
    Replies: 14
    Last Post: July 20th, 2010, 09:46 AM
  3. The Dremel Thread!
    By Atomic Dog in forum General
    Replies: 24
    Last Post: September 30th, 2008, 07:02 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Local gun shops | Local shooting ranges | Philadelphia Shooting Ranges | Philadelphia Gun Shops | Pittsburgh Shooting Ranges | Pittsburgh Gun Shops