Results 1 to 10 of 32
Thread: Fix a hole in an AK 47 barrel
Threaded View
-
September 1st, 2017, 11:33 PM #10
Re: Fix a hole in an AK 47 barrel
that front one is deep.... i wouldnt try to fill the hole, just put a spot over it then smooth out. its close enough to the end that pressures will be "low" and worst case youll get some gas leakage. you could fill with jb weld and smooth out the front sight will hold it in place. next time use a wider drill and dont go deep, it will weaken the dimples just enough to let them move when you press the sight off.
Similar Threads
-
How bad is this hole ?
By MikePrekopa in forum GeneralReplies: 8Last Post: June 1st, 2010, 09:44 AM -
One in the hole...
By NoName011 in forum Concealed & Open CarryReplies: 1Last Post: May 20th, 2010, 10:44 AM
Bookmarks