Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 10 of 42

Thread: Looking for advice on buying a case trimmer.

Thread Tools
Display
- Switch to Linear Mode
- Switch to Hybrid Mode
- Threaded Mode

Threaded View

July 8th, 2017, 05:07 PM #1
Remington788

View Profile

View Forum Posts

Private Message

Grand Member
Join Date

Feb 2012

Location

Montco, Pennsylvania
(Montgomery County)

Posts

4,171

Rep Power

21474853
Looking for advice on buying a case trimmer.

I am primarily loading just .223 for an AR but load small quantities of .30/30 and 7.62x54r.

Presently I trim using a Lee case gauge and cutter. http://leeprecision.com/gage-holder-223-rem.html
Then I use as chamfer tool on the inside and outside of the case mouth.
This is quite tedious and I am looking for a better alternative.

I was looking at
http://leeprecision.com/deluxe-quick...e-trimmer.html

Thoughts or alternates?

Eta. Oh. I'm working on a small budget

Last edited by Remington788; July 8th, 2017 at 05:20 PM.

Reply With Quote