trouble with CZ 75B-01

[joeyj]

On my last range trip the slide would not stay open after the last round was fired. When I got home I cleaned it real good or so I thought. I looked it up on YouTube and I come to the conclusion that I have been over oiling it because it was dirty in the corners and down in the trigger mechanism. My question is, is there a spray that I could use to get into those hard to reach spots, but at the same time won't hurt the plastic. Your advice will be greatly appreciated. Joe

[frankski]

Use Gunscrubber.

https://www.walmart.com/ip/Gun-Scrub...eaner/21949945

Use it outdoors. Spray it, let it drip out, wipe off, allow to dry. Lube very lightly only where your gun manual says to do so.

[Brian Ahearn]

I have a lot of CZ and CZ clones ,I clean and lube all of them with Remoil in the green and yellow spray can .never have any issues.