Results 1 to 3 of 3
Thread: trouble with CZ 75B-01
-
May 22nd, 2017, 08:36 AM #1Senior Member
- Join Date
- Jan 2011
- Location
-
Pgh
(Allegheny County) - Posts
- 410
- Rep Power
- 100515
trouble with CZ 75B-01
On my last range trip the slide would not stay open after the last round was fired. When I got home I cleaned it real good or so I thought. I looked it up on YouTube and I come to the conclusion that I have been over oiling it because it was dirty in the corners and down in the trigger mechanism. My question is, is there a spray that I could use to get into those hard to reach spots, but at the same time won't hurt the plastic. Your advice will be greatly appreciated. Joe
-
May 22nd, 2017, 08:41 AM #2Super Member
- Join Date
- Oct 2013
- Location
-
'burbs,
Pennsylvania
(Bucks County) - Posts
- 788
- Rep Power
- 21474847
Re: trouble with CZ 75B-01
Use Gunscrubber.
https://www.walmart.com/ip/Gun-Scrub...eaner/21949945
Use it outdoors. Spray it, let it drip out, wipe off, allow to dry. Lube very lightly only where your gun manual says to do so.
-
May 22nd, 2017, 01:31 PM #3Grand Member
- Join Date
- Dec 2010
- Location
-
Easton,
Pennsylvania
(Northampton County) - Posts
- 1,378
- Rep Power
- 21474851
Re: trouble with CZ 75B-01
I have a lot of CZ and CZ clones ,I clean and lube all of them with Remoil in the green and yellow spray can .never have any issues.
www.EastonFirearmsRefinishing.com Owner/Operator, NRA Pistol Instructor
Similar Threads
-
Trouble with XD-S 9mm?
By zerofloat857 in forum PistolsReplies: 6Last Post: June 13th, 2014, 10:10 AM -
Car trouble
By jsb889 in forum GeneralReplies: 19Last Post: May 5th, 2009, 06:16 PM -
Can I get into trouble?
By Bonneville in forum GeneralReplies: 2Last Post: January 13th, 2009, 04:33 PM -
I need help without getting into trouble.
By dylan in forum GeneralReplies: 10Last Post: September 25th, 2008, 08:13 PM
Bookmarks