Results 1 to 5 of 5
Thread: Please help identify small part
-
May 18th, 2017, 11:26 PM #1Member
- Join Date
- May 2016
- Location
-
Fenton,
Missouri
- Posts
- 87
- Rep Power
- 214756
Please help identify small part
Found on floor where I clean my guns. Can anyone identify as part of Smith & Wesson 500 Magnum, Remington 1911 R1, or Sig Sauer P238? It's about .25 in diameter, and about .25 in long, the small shaft is about .125 diameter.
http://imgur.com/TfaEDNM
http://imgur.com/NmCOBRc
http://imgur.com/40aoCK8
I just took the plate off my 500 Magnum which exposed the trigger and all the internal stuff. Also took cylinder ejection mechanism apart.
Hope someone can help.
Thanks
Bruce
-
May 19th, 2017, 12:18 AM #2Grand Member
- Join Date
- Aug 2009
- Location
-
bloomsburg,
Pennsylvania
(Columbia County) - Posts
- 1,605
- Rep Power
- 21474852
Re: Please help identify small part
It’s the Mainspring Housing Pin Lock to your Sig 238.
http://www.gunpartscorp.com/Products/1512690.htm
Check out part 33 on this diagram. It will show you were it goes.
http://www.gunpartscorp.com/Manufact...397.htm?page=3
-
May 19th, 2017, 12:35 AM #3
Re: Please help identify small part
I was going to suggest it fit the end of a spring, but looks like eagleclaw nailed it!
Illegitimus non carborundum est
-
May 19th, 2017, 07:02 AM #4Member
- Join Date
- May 2016
- Location
-
Fenton,
Missouri
- Posts
- 87
- Rep Power
- 214756
Re: Please help identify small part
Awesome. I ended up having to reset the ejection lever on the sear spring because I pushed it down too far while cleaning the gun. It must have popped out when I did that. Thanks a lot, eagleclaw. It's a relief to know where it goes. I had a heck of a time getting that sear spring in there just right. Not looking forward to that again.
Bruce
-
May 19th, 2017, 08:25 PM #5Member
- Join Date
- May 2016
- Location
-
Fenton,
Missouri
- Posts
- 87
- Rep Power
- 214756
Re: Please help identify small part
With the info provided was able to disassemble the 380, replace the part and reassemble it. I even made friends with the sear spring, was no problem to get it in there correctly.
Similar Threads
-
Identify what I have in the box......
By bripro in forum Gun PicturesReplies: 30Last Post: July 22nd, 2014, 10:15 PM -
Small boat for small lake
By soup in forum GeneralReplies: 1Last Post: March 31st, 2009, 02:28 PM -
Small part of my family!
By LX Kid in forum GeneralReplies: 7Last Post: July 27th, 2008, 10:39 PM
Bookmarks