Where to get a part I need.

[Clyde1993]

Hi guys, I've recently inherited a Western Marshal .357mag. by Hawes Firearm Co. 005_edited-2.jpg

I'm missing the part that is circled (the screw looking bit). I was wondering if anyone knew where I could get that part and what it is called.

Thank You.

[gghbi]

It is called a Base Pin Catch Assembly, and I was going to suggest Numrich, but they are sold out.



http://www.gunpartscorp.com/Manufact...tm?results=All

They do have small frame ones for Herbert Schmidt, which is another German maker of similar guns. http://www.gunpartscorp.com/Products/78920I.htm maybe you could call and see if they could measure it. Do you have any of the parts?

[Clyde1993]

It is called a Base Pin Catch Assembly, and I was going to suggest Numrich, but they are sold out.

http://www.gunpartscorp.com/Manufact...tm?results=All

They do have small frame ones for Herbert Schmidt, which is another German maker of similar guns. http://www.gunpartscorp.com/Products/78920I.htm maybe you could call and see if they could measure it. Do you have any of the parts?

Awesome thank you. I'll have to look around and see if I can find it. Not quite sure what you mean by your question if I have any of the parts, but I have the full gun itself and everything is on it. Just need that one part.

[raxar]

Contact Enck's gun barn, they do a lot of work on single action stuff, so they may be able to get something that works, it can't be that hard of a part to duplicate.

[762xIan]

Also try Jack First.....they are as big as Numrich but do NOT have parts listed online. You have to call them.

Link to website: https://jack-first-gun-parts.myshopify.com/

[39flathead]

If you can't find one, I'd almost bet that one from a Ruger Blackhawk would work.
For $20 you could try one, might need a little fitting but maybe not.