Results 11 to 12 of 12
Thread: Information needed on S&W 629
-
August 14th, 2019, 08:23 AM #11
Re: Information needed on S&W 629
Did you remove the grips to check if it’s stamped on the butt of the revolver?
DDG-8 "Sine Timore"
-
August 14th, 2019, 11:18 AM #12
Re: Information needed on S&W 629
I think you are probably looking at an assembler/fitter's number. The official position of the serial number is on the bottom of the grip frame (you may have to remove the stocks, dependent on type). They are also usually stamped on the frame, along with the model number, under the yoke. A 629-3 serial number would be in the new format which would be three alpha characters followed by four numeric characters.
Adios,
Pizza BobNRA Benefactor Member
Similar Threads
-
County Carry Permit Information - We need your help gathering information.
By danp in forum Concealed & Open CarryReplies: 99Last Post: August 20th, 2012, 01:30 PM -
Information needed regarding deceased ownership
By Ven in forum GeneralReplies: 4Last Post: March 1st, 2012, 07:50 PM -
Camp Perry information needed
By puccini in forum GeneralReplies: 6Last Post: February 14th, 2012, 10:55 PM -
Law information needed
By 814RuttinBuck in forum Concealed & Open CarryReplies: 28Last Post: July 23rd, 2011, 01:23 AM -
Reloading Information Needed.
By acbird0311 in forum Ammunition & ReloadingReplies: 17Last Post: January 8th, 2011, 09:43 AM
Bookmarks