Results 1 to 4 of 4
Thread: Old Rossi Model 68 Question
Threaded View
-
February 4th, 2017, 09:49 AM #1Member
- Join Date
- May 2014
- Location
-
Moscow,
Pennsylvania
(Lackawanna County) - Posts
- 33
- Rep Power
- 0
Old Rossi Model 68 Question
I have recently repaired a Rossi M68 3" revolver. It was missing the ejector rod and center pin. I have installed both and the gun is functioning. The back and forth lock up on the cylinder is impressive for the age of the gun, however the left right is concerning. Toward the rear of the cylinder, there is an insignificant amount of play, but toward the front near the arm, there seems about 1/32 of left/right. How do I tighten up the front of the cylinder? The hand is not worn and otherwise all function is good. Thanks!
Similar Threads
-
Rossi Model 62
By ShortRound45 in forum GeneralReplies: 4Last Post: February 21st, 2011, 09:41 PM -
rossi .38 model 351
By yldwill in forum GeneralReplies: 5Last Post: February 13th, 2009, 07:29 PM
Bookmarks