I finally finished my mosin build - purists dont look :)

[jl6665]

So I have been building this rifle for a while now, and, yes, I have heard it all, its just a mosin, you have more in the stock than what the gun is worth, why bother, and so on, well, I did it because I wanted to, and, I love it. it shots sub moa at 100yds and I could not be happier with it, so, in all its glory:

Pro Mag Archangel stock
Timney trigger
Rock Solid Industries Scope Mount
Rock Solid Industries Bent Bolt and knob
Barrel cut to 22" and crowned
Pro Mag 10rnd magazine
Harris Bipod
Vortex Viper 6.5-20X50 Scope

[MovingtoAmerica]

Nice! You should post some pictures of targets.

[jl6665]

I will be trying out some new loads on Tuesday, will post up the results ��

[JDA58]

Looks good!!
and if you are happy , that's all that really matters

[Emptymag]

I like it.

[n1fhpa]

Nice! Who cut the barrel?

[jl6665]

Nice! Who cut the barrel?

Sietzinger in West Newton, did a great job.

[PA1936MN]

Very nice!

I have that same mount and it is solid as can be.

I've got the trigger too and it breaks like glass!

[Hawk]

Are you a member of PMSC in Monroeville? I remember seeing a member shooting a similar setup this past summer (on Sundays).

[jl6665]

Are you a member of PMSC in Monroeville? I remember seeing a member shooting a similar setup this past summer (on Sundays).

Hi Hawk,

Yes, that's me, at the time I had a different scope, the barrel work had not been done and I was shooting surplus ammo. We spoke about the steel that used to be at the 300yd mark. I went and bought some 8" AR500 plates and portable target hanger to setup down there next time