Results 1 to 6 of 6
-
December 22nd, 2016, 10:34 PM #1Junior Member
- Join Date
- Dec 2016
- Location
-
Monaca,
Pennsylvania
(Beaver County) - Posts
- 4
- Rep Power
- 0
.30-06 150 Grain Load using IMR 4451 and Hornady SST
Folks,
just wanted to pass on the GREAT results i'm getting with IMR 4451 and a 150 grain Hornady SST over a max (compressed) load of this powder. I shoot sub MOA and on two trigger pulls, accounted for two dead deer, bang flop, and bang run 10 yards, flop. Its greatly impressed me and is my new favorite powder!
Hornady Brass
CCI 200 LR primer
57.8 Grains compressed IMR 4451 (max load)
Hornady 150 grain SST, Seated to bullet canneleur to replicate factory ammo.
1/2 MOA at 100 yards.
-
December 27th, 2016, 10:25 PM #2
Re: .30-06 150 Grain Load using IMR 4451 and Hornady SST
Great! Now I gotta find room for anotherpowder for my 22-250! Thanks!
-
December 29th, 2016, 11:13 PM #3Junior Member
- Join Date
- Dec 2016
- Location
-
Monaca,
Pennsylvania
(Beaver County) - Posts
- 4
- Rep Power
- 0
Re: .30-06 150 Grain Load using IMR 4451 and Hornady SST
Hahaha! I'm going to try the new enduron series of powder in .243 as well. Not sure which yet! Hoping for 4451!
-
December 29th, 2016, 11:27 PM #4
Re: .30-06 150 Grain Load using IMR 4451 and Hornady SST
Attachment 92266
Is it normal for 1/2 moa on factory ammo at 100 yards?
Attachment 92267Last edited by thefirstndsecond; December 29th, 2016 at 11:31 PM.
-
December 30th, 2016, 01:42 AM #5
-
December 30th, 2016, 01:45 AM #6
Re: .30-06 150 Grain Load using IMR 4451 and Hornady SST
What rifle are you shooting this with? What's your twist rate? Barrel length? Any crimp?
Also, show us 5 groups of 5 or 10 shots all sub-MOA and I might buy into this. 3-shot groups are generally only good for indications. A one shot group with any caliber under .50 will always be 1/2 MOA
That being said, I've found my Remi's don't particularly like <165gr pills. The Savage on the other hand does...YMMV
Regardless, good shooting OP and congrats on the two deer! Send some jerky my way!I'm only here for the wood c-rings.
Similar Threads
-
S&W 500 with 330 grain bullet load suggestions
By waveman in forum Ammunition & ReloadingReplies: 5Last Post: May 19th, 2013, 01:04 PM -
Need load for 300 grain lead using Unique
By WhiteWolf in forum GeneralReplies: 7Last Post: October 8th, 2009, 11:19 PM -
Need a .45 colt+p load for 230 grain
By crawlalapodo in forum GeneralReplies: 1Last Post: May 8th, 2009, 12:43 PM -
Highest Grain .223 Factory Load
By st.marys in forum GeneralReplies: 27Last Post: October 31st, 2007, 01:13 AM
Bookmarks