Results 1 to 8 of 8
-
July 21st, 2016, 10:28 PM #1
AR-15 Upper Vise Block Clamp & Vise Question..
Need to pick up a AR-15 Upper Vise Block Clamp ... What size Vise is needed to use the clamp..or.... Will it work in a 4" vise ?
Thanks
-
July 22nd, 2016, 06:40 AM #2
Re: AR-15 Upper Vise Block Clamp & Vise Question..
Anyone???? Hello
-
July 22nd, 2016, 07:43 AM #3Senior Member
- Join Date
- Dec 2013
- Location
-
Scott Twp,
Pennsylvania
(Allegheny County) - Posts
- 320
- Rep Power
- 4041166
Re: AR-15 Upper Vise Block Clamp & Vise Question..
A 4" vise seems more than a sufficient size for an upper block.
-
July 22nd, 2016, 10:26 AM #4
Re: AR-15 Upper Vise Block Clamp & Vise Question..
Before you get a tratidional vice block look at the Magpul Bev Block.
https://www.magpul.com/products/fire...-block-ar15-m4
It will hold the upper to allow you to install things like the forward assist and ejection port cover. But when installing the barrel it also engages the barrel extension so torque is not applied to the aluminum upper receiver. It can also be used as a lower vice block as well.
I just did an upper build with this and it worked perfect. I wish I had had it (and a bench and vice) when I had built the lower a while back.
I have a 6" vice and it was more than adequate.Last edited by QuackXP; July 22nd, 2016 at 10:29 AM.
"No, it's just a machine. I'm the weapon." - Jack Harper in Oblivion
-
July 22nd, 2016, 10:58 AM #5
Re: AR-15 Upper Vise Block Clamp & Vise Question..
The Magpul Bev block works well, I have one. Primary Arms runs them on sale fairly regular. I like it better than my Brownells reaction rod knockoff.
-
July 27th, 2016, 05:43 PM #6Junior Member
- Join Date
- Mar 2009
- Location
-
Birdsboro,
Pennsylvania
- Posts
- 17
- Rep Power
- 0
Re: AR-15 Upper Vise Block Clamp & Vise Question..
Depends if you are using a pin style upper block or the type that sandwiches the upper. I have a no mar vice set that works good but would be tight on a 4 inch vice. Also if you want to cheap out, just use a magpul pmag and leave the upper on the lower. Easy $10 vice block
-
July 27th, 2016, 05:52 PM #7
Re: AR-15 Upper Vise Block Clamp & Vise Question..
I got the type that sandwiches the upper. and its good to go with a 4" vise...
-
July 27th, 2016, 08:48 PM #8
Re: AR-15 Upper Vise Block Clamp & Vise Question..
4 inch Craftsman vise and NoMar blocks. Works just fine for barrel nut removal, and my RRA needed 2 foot of pipe on the end of an 18 inch breaker bar.
image.jpg
Bookmarks