I just bought a src ar15 for $450!

[timeisrelative]

That's exactly what I was thinking when I saw it. Gas block looks the infamous DPMS aluminum railed gas block.


"Mating" isn't really terribly difficult unless you use no-name bottom of the barrel parts or "Turn Out Parts as Fast as Possible for Profit During a Panic" parts.

Maybe "mating" wasn't exactly the right word. I've owned a couple of factory ar's and this one seems to be the best fitted one I've had. I have a psa and had a ban Era bushmaster (I know not top dollar stuff) but my bushmaster I actually put a rubber nub under the rear pin because it had a small gap between the upper and lower. This one fits almost perfectly. No slop at all. Either way, I'm happy with my deal. Lol!

[bripro]

Wow! Where are you buying build parts for $350 total?

Mainly from the classified section here. I also bought a bunch of Anderson lowers from Tropp when they were $49. The last one I did wound up being under 300 bucks.

[timeisrelative]

Mainly from the classified section here. I also bought a bunch of Anderson lowers from Tropp when they were $49. The last one I did wound up being under 300 bucks.

Wow! The other one I built with an unfired psa lower and a new psa freedom upper and a matech rear sight was right at $460. Even looking around at "budget" rifle kits and a $50 lower ends up at about $460. Wish I could find some to build for $300ish!

[sprrdhawk44]

They are the "reliabolt" people IIRC, the one that keeps breaking. Don't know much about them other than that.

Mine has been pretty good so far. Their carrier has been good, as well. Granted, mine may not be representative of the whole, as I don't have a huge number of rounds down range with them, but I haven't had issues in the time I have been using them. If nothing else, I'm sold again on how awesome Robar's NP3 is.

[awfroadan]

Is it chambered in .45-70?

Put a .458 Socom upper on it, they use 45-70 bullets. Close enough right? The modern buffalo rifle right there.