Looking for a gunsmith in Norristown/Montgomery county PA.

[ralphs007]

Hi
I'm looking for a gunsmith near Norristown PA. in Montgomery county. I'd like to get a set of Meprolight CZ Tru-Dot Night Sights installed on my Cz75d PCR.
Thanks in advance
Ralph

[ralphs007]

Never mind,I found one.

[Remington788]

Never mind,I found one.

Where?
How did it go?

[ralphs007]

I didn't find a gunsmith in Montgomery county.I found a guy in Chester county,from some of the reviews on this forum. He's one of the few gunsmiths, who answers his phone.Spring City Custom Firearms & Repair-‎351 Washington Street, Royersford, PA 19468-2537 (610) 792-0363‎
I'm getting these sights,http://www.amazon.com/TruGlo-Tritium.../dp/B0141PCJ12, installed on my CZ-75d PCR. I was tempted to install them myself,but I'm afraid I might break the tritium vials,tapping them onto the gun. Plus,not using a gunsmith for the install, voids the warranty,I'm not sure how they'd know,if I did or didn't use one.
As soon as they arrive from budsgunshop,I'll drop them off for the install. I have a hard time seeing the sights,that came on my cz75d pcr.These sights are supposed to be good in the daytime too,because of the tritium/fiber optics used together.
HTH
Ralph

[Muscle Master]

I didn't find a gunsmith in Montgomery county.I found a guy in Chester county,from some of the reviews on this forum. He's one of the few gunsmiths, who answers his phone.Spring City Custom Firearms & Repair-‎351 Washington Street, Royersford, PA 19468-2537 (610) 792-0363‎
I'm getting these sights,http://www.amazon.com/TruGlo-Tritium.../dp/B0141PCJ12, installed on my CZ-75d PCR. I was tempted to install them myself,but I'm afraid I might break the tritium vials,tapping them onto the gun. Plus,not using a gunsmith for the install, voids the warranty,I'm not sure how they'd know,if I did or didn't use one.
As soon as they arrive from budsgunshop,I'll drop them off for the install. I have a hard time seeing the sights,that came on my cz75d pcr.These sights are supposed to be good in the daytime too,because of the tritium/fiber optics used together.
HTH
Ralph

Thanks for the info.. I'll give him a call when I get my XDM... I'll be installing the TruGlo Pros

[DaveIam]

Just for any future reference, King's Shooting Supply has a gunsmith on hand and they are right in King of Prussia. I went there to look for an installation tool, they didn't have one, but offered to to do install right then while I waited.

[ralphs007]

Thanks,I live less than ten minutes from this place.