Results 1 to 10 of 12
-
September 26th, 2015, 07:26 PM #1Grand Member
- Join Date
- Jan 2009
- Location
-
eastern PA,
Pennsylvania
- Posts
- 1,358
- Rep Power
- 5632717
Tac-Sol M4 22 upper, windage issues...
I've owned one of the Tactical Solutions M4 22 uppers for over a year, but have not really gotten a chance to shoot it due to my work schedule.
Over the past 2-3 days I finally got around to shooting it (with a spectre II mounted on it), and have found that I need to adjust the windage on the rear sight almost all the way to the right. I've tried three different rear sights with the same results.
Guessing the FSB might not be aligned properly..Is this something a competent AR gunsmith can look into or should I just send it back to Tac-Sol for them to look at ?
-
September 26th, 2015, 07:52 PM #2
Re: Tac-Sol M4 22 upper, windage issues...
Bripro could take care of that front sight for you.
-
September 26th, 2015, 08:04 PM #3
Re: Tac-Sol M4 22 upper, windage issues...
^^^^😷
Adjusting the front sight post is easier said than done. The two taper pins are drilled through the bottom of the barrel when installed. This makes adjusting it, or in my case replacing it, very difficult. Perhaps a competent gunsmith can fix it but I havent come up with a solution for mine yet.
-
September 26th, 2015, 08:16 PM #4
Re: Tac-Sol M4 22 upper, windage issues...
I couldn't resist.
-
September 26th, 2015, 09:14 PM #5
Re: Tac-Sol M4 22 upper, windage issues...
Front sight base may have set screw, I had one and I think mine had one. If so easy fix, loosen set screw and adjust. I think the screw is under the sling swivel.
-
September 26th, 2015, 09:20 PM #6Grand Member
- Join Date
- Jan 2009
- Location
-
eastern PA,
Pennsylvania
- Posts
- 1,358
- Rep Power
- 5632717
-
September 26th, 2015, 09:25 PM #7
-
September 27th, 2015, 12:07 AM #8
Re: Tac-Sol M4 22 upper, windage issues...
My way of thinking is it if its just a set screw rather than taper pins you may be able to tap it over without even loosening it. Keep in mind that most of my things are damaged or broken though.
DDG-8 "Sine Timore"
-
September 27th, 2015, 12:22 AM #9
-
September 27th, 2015, 02:40 PM #10Grand Member
- Join Date
- Jan 2009
- Location
-
eastern PA,
Pennsylvania
- Posts
- 1,358
- Rep Power
- 5632717
Re: Tac-Sol M4 22 upper, windage issues...
Well, that was an easy fix. Rifle now shoots straight with the windage set a couple of clicks pass the center hash mark. A Couple of taps with a hammer and punch and the sling swivel rivet popped out...a couple of turns with the allen wrench and the FSB was loose. I think it was just dumb luck I got it right the first time around...
Similar Threads
-
S&W Governor Issues, Locked up while firing, possible internal lock issues
By yeahbuck36 in forum PistolsReplies: 15Last Post: June 7th, 2015, 04:26 PM -
FAL Rers Sight to a M16 A2 Dual Apture with Windage
By pistolenvoy in forum RiflesReplies: 1Last Post: July 4th, 2012, 08:45 AM -
Dope this for windage?
By smitty56 in forum RiflesReplies: 29Last Post: February 7th, 2011, 07:22 PM
Bookmarks