Results 1 to 4 of 4
Thread: Mt Joy work party-help needed
-
September 26th, 2014, 02:50 PM #1Active Member
- Join Date
- Mar 2013
- Location
-
Lancaster,
Pennsylvania
(Lancaster County) - Posts
- 160
- Rep Power
- 462233
Mt Joy work party-help needed
Another work party has been announced for Saturday, October 4th. The email failed to give a time but I would assume any time after 7 AM like last week. Bring gloves, shovels and digging irons, whatever you have.
Volunteers are also needed to take positions for next year of President, Vice President, Treasurer and Secretary.Last edited by vetman03; October 1st, 2014 at 02:42 PM.
-
September 29th, 2014, 04:03 PM #2Senior Member
- Join Date
- Apr 2006
- Location
-
Pennsylvania
(Lancaster County) - Posts
- 489
- Rep Power
- 544384
Re: Mt Joy work party-help needed
vetman,
I could not make the work party. But if you did I and I am sure others would appreciate a report on the situation and your opinion on if and when the ranges will be open. Did they have some heavy equipment there to move dirt?
-
September 29th, 2014, 08:42 PM #3Active Member
- Join Date
- Mar 2013
- Location
-
Lancaster,
Pennsylvania
(Lancaster County) - Posts
- 160
- Rep Power
- 462233
Re: Mt Joy work party-help needed
Because I only saw the email Friday morning I could not arrange to be there this week. If notices could be sent out a little earlier I should be able to help out as will my friend.
-
October 1st, 2014, 02:44 PM #4Active Member
- Join Date
- Mar 2013
- Location
-
Lancaster,
Pennsylvania
(Lancaster County) - Posts
- 160
- Rep Power
- 462233
Re: Mt Joy work party-help needed
Please note new work party for October 4th at the top.
Similar Threads
-
Heidelberg Sportsmens work party
By tripleS in forum LebanonReplies: 3Last Post: April 1st, 2014, 08:01 PM -
Work needed on Browning O/U skeet gun
By blawnoxboy in forum GeneralReplies: 0Last Post: November 29th, 2009, 12:12 AM -
Reliability work needed on a Colt 1911 - CPA
By Earthling in forum GeneralReplies: 4Last Post: October 28th, 2009, 10:13 AM -
(Blair Co)Gunsmith needed for barrel work
By halo23pa in forum GeneralReplies: 3Last Post: April 4th, 2009, 02:00 PM -
Rossi .357 Magnum Levergun work needed
By Swarner793 in forum GeneralReplies: 2Last Post: December 19th, 2008, 09:55 PM
Bookmarks