Results 1 to 2 of 2
-
February 8th, 2014, 02:07 PM #1Junior Member
- Join Date
- Nov 2012
- Location
-
Nottingham,
Pennsylvania
(Chester County) - Posts
- 21
- Rep Power
- 0
Hammer/Disconnector issues on my AR. Help/Info?
Hey there I need some help I have two I believe their Stag LPK's and the Fire Control Group is giving me a bit of a problem. After I installed the LPK I tested the trigger/hammer and the hammer is getting caught up on the Disconnector this is happening to both of my Kits. Is this something to be worried about? It will get caught on the Disconnector for a second then when it engages it releases. Just though I would make sure if it was a problem or not before firing any help is very much appreciated. Thank you.
-
February 8th, 2014, 02:16 PM #2
Re: Hammer/Disconnector issues on my AR. Help/Info?
I'm not sure how you're testing so....
Try this.
With the hammer cocked pull the trigger. Ride the hammer forward while keeping the trigger pulled to the rear. Push the hammer back to the cocked position. At this point the disconnector should hold the hammer. Release the trigger and the disconnector should release while the hammer stays in the cocked position.
The hammer will jump just a bit when the disconnector releases.
Similar Threads
-
Backyard Target Shooting and Legality Issues-Info needed
By Shianne in forum GeneralReplies: 6Last Post: January 2nd, 2013, 12:28 AM -
Walther P22 - Light hammer strike issues
By West Chester in forum PistolsReplies: 8Last Post: March 21st, 2010, 07:33 PM -
Glock optional disconnector?
By Mity2 in forum GeneralReplies: 13Last Post: June 5th, 2008, 05:46 PM
Bookmarks