Results 1 to 3 of 3
Thread: Glock 20 spring question
-
March 2nd, 2013, 09:41 PM #1
Glock 20 spring question
i have a glock20 with 6'' LW barrel and l just got a few boxes of DT 230gr. WFNGC Hardcast and i remember hearing that you need to change recoil springs and something about light primer strikes is this something i should look into or is my stock g20 up to the task?
thanks,
-
March 2nd, 2013, 09:54 PM #2
Re: Glock 20 spring question
I had the same setup and put the 22 lb spring in, I never changed the firing pin spring that came with the kit. Function wise it was fine. Was less accurate then the stock configuration by far. Sold the whole mess and bought a G29. Im thinking about getting another G20 and leaving it stock except for some better sights maybe.
-
March 2nd, 2013, 11:38 PM #3
Re: Glock 20 spring question
I never had any issues with the 230gr out of my G20, iirc the only problem was the factory glock rifling not being able to stabilize the bullet correctly, which your LW barrel solves this issue.
Mostly browsing these days, and expanding the collection.
Similar Threads
-
Odd question regarding AR-57 and AR-15 buffer/spring ...
By adoddere in forum RiflesReplies: 9Last Post: October 2nd, 2012, 05:35 PM -
ar15 gurus-buffer spring question
By blysccr in forum GunsmithingReplies: 23Last Post: July 31st, 2012, 08:19 PM -
Buffer Spring Lube Question
By richrock in forum RiflesReplies: 8Last Post: July 31st, 2010, 03:14 AM -
Magazine Spring Question XDs
By Kenshin in forum GeneralReplies: 5Last Post: March 2nd, 2007, 10:20 PM
Bookmarks