Results 1 to 3 of 3
-
February 28th, 2013, 02:02 AM #1Banned
- Join Date
- Feb 2013
- Location
-
Bryn mawr,
Pennsylvania
(Montgomery County) - Age
- 40
- Posts
- 53
- Rep Power
- 0
Remington 597 30 rd mag suggestions
Hole im in the right spot. Recently bought 5 30 rd remington 597 mags and out of the four I checked so far 2 have had the same issue. The part where bullet sits gets stuck a few inches down the length of the magazine. This causes subsequent rounds to wiggle around in the space between. It def won't feed like this. I have to slam the mag against something to unstick and get the part to come back up. I tried to sand the plastic parts that guides it up to no avail. Any suggestions would be greatly appreciated.
Should I just send it back?
-
February 28th, 2013, 07:57 AM #2Grand Member
- Join Date
- Jun 2011
- Location
-
Windsor,
Pennsylvania
(York County) - Posts
- 1,208
- Rep Power
- 1450701
Re: Remington 597 30 rd mag suggestions
Usually a sticky follower is due to poor lubrication. I would not have sanded anything as that usually leaves a rougher ( hence more friction ) surface that sticks more. I would recommend going over the surfaces you sanded with ultrafine steel wool or a polishing compound to make them glassy smooth, and then use a silicone base or other water repelling lubricant such as white lithium grease ( I'm assuming they're all plastic except for the spring and feed lips ). Hopefully, this will solve your magazine problem.
-
February 28th, 2013, 09:55 PM #3Banned
- Join Date
- Feb 2013
- Location
-
Bryn mawr,
Pennsylvania
(Montgomery County) - Age
- 40
- Posts
- 53
- Rep Power
- 0
Re: Remington 597 30 rd mag suggestions
Yea after I sanded the one I realized that probably wasn't a good idea bc of the friction. I checked the last of the 5 I bought. 3 were bad!!! That's not even 50% success rate. The whole magazine is plastic besides the spring. I've included a picture. It's crazy remington would put out these POS. I'll try your suggestion, thanks for responding
Similar Threads
-
New .308 Remington 700 5R build...advice, suggestions, opinions appreciated
By Agent Smith in forum RiflesReplies: 25Last Post: June 28th, 2011, 06:19 PM -
First AK-- suggestions
By Eugene V. Debs in forum GeneralReplies: 20Last Post: October 23rd, 2008, 12:17 AM -
Looking for suggestions
By ironhorse in forum GeneralReplies: 1Last Post: May 31st, 2008, 08:02 PM -
40 S&W suggestions
By ah141nj in forum GeneralReplies: 47Last Post: May 12th, 2008, 10:14 PM -
Suggestions for a 380
By Mtbkski in forum GeneralReplies: 59Last Post: February 23rd, 2008, 01:06 PM
Bookmarks