Results 1 to 4 of 4
Thread: Melonite and Kydex - Finish Wear
-
December 27th, 2012, 10:09 PM #1Junior Member
- Join Date
- Apr 2012
- Location
-
Tunkhannock,
Pennsylvania
(Wyoming County) - Posts
- 20
- Rep Power
- 0
Melonite and Kydex - Finish Wear
I just assembled two Old Faithful holsters, the Crossbreed style IWB Kydex. They fit great and I wore my Nano the past few days and it rode great.
I set up my XDM one tonight and drawing and holstering I noticed some small scratches on the slide. Since the gun s like new and been out to the range twice I don't think the scratches were there before. I'm not worried about the scratches, but I thought the retention was good and I'm concerned about wearing the finish down or off wearing the holster to break it in. Any ideas?
-
December 27th, 2012, 10:13 PM #2
Re: Melonite and Kydex - Finish Wear
www.Steelvalleycasting.com is your new home for coated bullets and custom ammo.
-
December 27th, 2012, 11:33 PM #3
Re: Melonite and Kydex - Finish Wear
I would think that since melonite is harder then kydex, scratch comes from elsewhere?
On the side note, as Ducayi said, some wear on gun makes it very appearing.
Here is few sexy well worn MEU1911's...
Oh the story they could tell...Last edited by Mity2; December 27th, 2012 at 11:38 PM.
Audemus jura nostra defendere
-
December 28th, 2012, 12:19 AM #4Grand Member
- Join Date
- Jan 2008
- Location
-
Henryville,
Pennsylvania
(Monroe County) - Posts
- 3,583
- Rep Power
- 26032
Re: Melonite and Kydex - Finish Wear
You pay for that "excellent detention" with scratches.
Personally i hate Kydex, i only have one and its for my CW9 , nothing to scratch there.
If you have a Gun that you really like Dont carry it in Kydex.
Similar Threads
-
Melonite Refinishing?
By Spray'n'Pray in forum GunsmithingReplies: 2Last Post: December 28th, 2012, 11:10 AM -
Severe finish wear on 1911... Should I take extra steps to protect the steel?
By snakeman21 in forum PistolsReplies: 7Last Post: December 23rd, 2012, 01:33 AM -
To finish or not to finish? Opinions
By dteed4094 in forum RiflesReplies: 2Last Post: August 16th, 2010, 08:43 PM -
Will my new Don Hume IWB wear the finish on my polished inox Beretta?
By Zet70 in forum PistolsReplies: 3Last Post: July 2nd, 2010, 09:56 AM
Bookmarks