A Fobus holster that is too tight and makes the draw difficult

**Dogpupkus** · December 27th, 2012, 01:13 PM

OP: Use a hair dryer. Heat the holster up for 5 minutes in the trigger guard area, then stretch it apart, almost to 90 degrees. It'll eventually retain it's original shape, but will be a much better fit. Fobus has come a long way, the holsters they make now are quite lovely. If you have an Evolution series, use the tension adjustment screw.

Also, It'll be hard to destroy it. If you ever do though, they do have a lifetime warranty. No questions asked.

Originally Posted by CHEMICAL

Wait what??!!! No it's not. A paddle holster is designed to be worn between the pants and the underwear.

This is correct.

Originally Posted by Brownie 56

Can be worn either way. If you have an issue with it pulling out with the gun then just wear it between your pants and belt. My mistake for saying it was designed to be worn between the belt and pants. It is designed for both.

Fobus paddle holsters are designed to be worn with the paddle inside the waistband. If you wear a belt, and have the paddle in your pant waistband, it won't pull out when you draw. If wearing it with the paddle outside works for you and you're happy, that's all that matters!

**allglock** · December 27th, 2012, 01:48 PM

I am pretty partial to mine. Whats not to like? Less than $20, easily taken on and off, lightweight, very snug to body. I like the fact it is a little hard to remove (by someone else, that is)

The only way it could be any better is if it were to ride a little higher... Thats it!