Glock 19 Extended slide release

[MARINE DIVISION TWO]

Cant get the larger of the two pins out,Is there a trick to this,Am I missing something to do other than take it to a Glock Armorer ? I changed my sights,Mag release and extended slide take down no problem,Just cant get the larger pin to move,I am pushing left to right in case the pin has a shoulder,Help !

[GreenBlood10]

I know when I installed the extended slide release on my Glock 27 those pins were a little difficult to get out. They needed a little more persuading than the others. It shouldn't be too difficult though, hopefully someone can give you another tip/trick.

GB

[West Chester]

Try pushing right to left...

[kbcobra26]

Looks like it's left to right..

Skip to 3:10 in the vid.

[MARINE DIVISION TWO]

Looks like it's left to right..

Skip to 3:10 in the vid.

Glockmeister video says and shows left to right,but cant budge the larger of the pins,I dont think Glock would have put loctite on as a joke although It IS that tough !

[red dog]

these can be tough the first couple of times. this pin has two grooves cut into it. a good punch and a light hammer can help, don,t go crazy! also jiggle the slide stop around as you try. go left to right.

[JasonK007]

these can be tough the first couple of times. this pin has two grooves cut into it. a good punch and a light hammer can help, don,t go crazy! also jiggle the slide stop around as you try. go left to right.

Wiggling the existing slide release while trying to push out the pin is the way to go. I've swapped out 6 of these so far. The little grooves in the factory slide release get caught up. Also, I never use a hammer when trying to take Glock pins out. Usually, just pushing them with a punch will do the trick. Having to use a hammer means you may be caught up on something which could get damaged by whacking on the pin.

[Brian Ahearn]

Marine Division Two If you are having a problem getting it done stop down and see me .your not that far away. It only takes a couple of minutes I will show
you how to do it no charge,Brian / EFR

[CHEMICAL]

Wiggling the existing slide release while trying to push out the pin is the way to go.

Bingo! Absolutely 100% your answer right here! Forward and back

[MARINE DIVISION TWO]

BINGO ! Wiggling the slide release was the ticket,It came out with a little push,all the videos I found do not tell you to wiggle the release,Thank you ALL for the info,Once again the members came thru for me,Happy Shooting ! And reps sent.