Results 1 to 3 of 3
Thread: Refinish A Revolver ?
-
July 31st, 2012, 05:41 PM #1
Refinish A Revolver ?
Is there anything that I can have done to my old S&W Chiefs Special than getting it reblued? It is just starting to get pitted and the blue is worn off from holster wear at the barrel. Is there a tougher finish?
[SIGPIC]
-
July 31st, 2012, 07:51 PM #2
Re: Refinish A Revolver ?
You can have it Cerakoted. The coating wears very well, and when done correctly will fill in minor pitting and make other pitting less obvious. There are several of us around PA that do Cerakoting.
Ron USAF Ret E-8 FFL01/SOT3 NRA Benefactor Member
-
July 31st, 2012, 08:51 PM #3Member
- Join Date
- Jul 2010
- Location
-
Hellertown,
Pennsylvania
(Northampton County) - Posts
- 76
- Rep Power
- 481
Re: Refinish A Revolver ?
Since it's a S&W you could also send it back to factory to have it redone. I never realized they did that until I started digging on their site. I have a very old M & P that's been in my family for years and the finish is about all worn off so I was considering sending back to the factory. Surprisingly it's not that expensive.
"The Earth is for the living." -Thomas Jefferson
Similar Threads
-
Looking to Refinish a Beretta
By 96D in forum GunsmithingReplies: 1Last Post: July 25th, 2012, 09:12 PM -
my WASR 10/63 refinish
By Gooseaholic in forum Gun PicturesReplies: 18Last Post: January 31st, 2012, 07:06 PM -
Refinish or leave it?
By das in forum PistolsReplies: 10Last Post: June 1st, 2011, 07:01 PM -
CZ-82 Refinish
By cruzans in forum PistolsReplies: 17Last Post: March 24th, 2011, 12:04 PM -
Refinish 1911
By BigMikeM31 in forum GunsmithingReplies: 10Last Post: February 1st, 2010, 09:36 PM
Bookmarks