I need a gunsmith in NEPA that can thread a barrel

**redturbo0** · March 5th, 2012, 12:50 AM

Close to Wilkes-Barre, to do work on my Remington 700 SPS

I'd like for the barrel to be cut about 2 inches and threaded, but when not using the suppressor I'd like for the cut off two inches to act as a cap for the threaded barrel.

If you know of any reasonable gunsmith capable of this job, please let me know. Thank you!

EDIT: Doesn't have to be exactly near Wilkes-Barre, I'm willing to travel maybe like a half hour or 45 minutes away for this kinda work.

**Breadman03** · March 5th, 2012, 08:22 AM

Try Dave's Gunshop in Drums. I've never had work done by him, but asked around a bit and everyone recommended him.

**wheeling365** · March 5th, 2012, 08:41 AM

http://forum.pafoa.org/members/up-in-arms-designs-inc/

http://www.upinarmsdesigns.com/www.u....com/Home.html

This shop is fairly local and I've shot some of their work they did for a friend.

**cdi** · March 5th, 2012, 11:29 AM

I am probably too far for you to drive, looks like 2 hours +

You could always mail it. Turnaround is 2 weeks or less.

**redturbo0** · March 5th, 2012, 12:01 PM

Originally Posted by Breadman03

Try Dave's Gunshop in Drums. I've never had work done by him, but asked around a bit and everyone recommended him.

I'll check them out, thanks

Some one just told me about this place too, http://www.rwhart.com/index.asp

They seem to do good work and have a reputation for improving accuracy.