Kimber grip?

**vetter3006** · February 23rd, 2012, 08:19 AM

Am looking to change my grips on my Kimber custom stainless TLE II and was looking at the Kimber rosewood grips but I see they have full length and a slim grip full length. Does anyone know how much of a difference it is between the two?

**Pizza Bob** · February 23rd, 2012, 09:48 AM

**Mity2** · February 23rd, 2012, 01:34 PM

Thin grip is nice.
However, it'll require you to change the grip screw bushing to thin profile model, and shorter grip screw and those bushing are usualy a bitch to remove without the proper tool..
And also if you dicide to replace plastic MSH with one with magwell, then I belive you'll need magwell made for thin grip as well

**vetter3006** · February 23rd, 2012, 03:28 PM

Was only going to change the grips.
looks like the full length would be best as that is the same as what came on it from the factory.

**Mity2** · February 23rd, 2012, 04:32 PM

I like 1911 with Full grip.
I never did like the cutoff butt for the access of MSH pin.
I understand the reason, but I just think it look silly.
As well as the angled cut on bottom.