Results 1 to 10 of 19
Thread: glock 27 problems
-
February 18th, 2012, 04:42 PM #1
glock 27 problems
Does anyone one know why my slide doesn't stay opened when the last round is fired, and if I pull up on the slide lock it stays back after every round is shot. not good for a self deffence gun, any ideas!!!!! or should I just go see a gun smith!!!!!??????
-
February 18th, 2012, 05:08 PM #2Active Member
- Join Date
- May 2011
- Location
-
ephrata,
Pennsylvania
(Lancaster County) - Posts
- 169
- Rep Power
- 163068
Re: glock 27 problems
if you insert a empty mag and rack the slide does it lock back
-
February 18th, 2012, 05:09 PM #3Grand Member
- Join Date
- Jan 2007
- Location
-
OUT TO LUNCH
- Posts
- 4,560
- Rep Power
- 21474858
Re: glock 27 problems
It sounds as though your slide stop is installed incorrectly. Did you install an aftermarket one? Either way, the TOP PIN needs to be installed first on reassembly to insure the curved piece of spring steel on the slide stop goes UNDER it ensuring that the slide stop works properly. To test it, take your slide off and lift up on the slide stop. It should spring downward.
JulesLast edited by ar15jules; February 18th, 2012 at 05:16 PM.
-
February 18th, 2012, 05:48 PM #4
Re: glock 27 problems
You may have a bad mag spring or you be be riding the slide stop when shooting the gun.
-
February 18th, 2012, 05:50 PM #5Senior Member
- Join Date
- Sep 2008
- Location
-
Effort,
Pennsylvania
(Monroe County) - Age
- 48
- Posts
- 372
- Rep Power
- 2241
Re: glock 27 problems
If you push up on the slide stop, of course it will stay open for every shot. You also may be manipulating the slide stop with your thumbs while you shoot.
-
February 18th, 2012, 06:23 PM #6
Re: glock 27 problems
And a good way to check if you thumbs are hitting the slide stop when shooting is to shoot one handed. If it locks back on last round shooting one handed, adjust your grip.
Also good to try different magazines.
-
February 18th, 2012, 06:25 PM #7Member
- Join Date
- Apr 2007
- Location
-
Slatington,
Pennsylvania
(Lehigh County) - Posts
- 48
- Rep Power
- 0
Re: glock 27 problems
Could be a couple of things as mentioned, insert an empty magazine and attempt to lock the slide back manually, if this works you are more than likely riding the slide release with your grip. To know for sure shoot the pistol left hand only I am assuming your right hand dominant ? If that solves your problem look no further, you will just have to modify your grip to avoid riding the slide release.
If the above does not work, remove the slide and lift up on the slide release it should snap back down under its spring pressure. If it does not then more than likely it is installed incorrectly. The locking block pin is the first pin out and first pin back in during disassembly/reassembly, the locking block pin also retains the slide release spring. Make sure it is installed correctly there are an awful lot of disassembly videos all over the internet.
Should solve your problemsLast edited by wlptpd3; February 18th, 2012 at 06:27 PM.
-
February 18th, 2012, 08:20 PM #8Grand Member
- Join Date
- Dec 2010
- Location
-
back to Port Charlotte,
Florida
- Age
- 60
- Posts
- 5,483
- Rep Power
- 3627622
Re: glock 27 problems
If you check all of the above and still have trouble, make sure the mag follower is coming all the way up. It could be hanging up near the top of the mag.
BCM and Glock...for a bigger pile of 'cold dead hands' brass.
-
February 19th, 2012, 07:34 AM #9
Re: glock 27 problems
I would go with you're probably riding the slide stop lever during recoil and just not allowing the slide to lock open.
-
February 19th, 2012, 12:58 PM #10
Re: glock 27 problems
My glock is totally stock, and am pretty sure my thumb is not doing it,it doesn't lock back with an empty mag in, I have to push up on the lock.
Similar Threads
-
Glock Problems
By Huntin'Fool in forum GeneralReplies: 28Last Post: December 28th, 2009, 03:33 PM -
glock 27 problems
By wheeling365 in forum GeneralReplies: 24Last Post: November 26th, 2009, 10:46 PM -
9mm Glock Problems
By phill in forum GeneralReplies: 10Last Post: March 15th, 2009, 12:34 AM -
h-335 problems
By idpasharpshooter in forum GeneralReplies: 16Last Post: February 13th, 2009, 03:45 AM -
Problems with my Glock 21!
By D-FENS in forum GeneralReplies: 76Last Post: April 29th, 2007, 09:56 PM
Bookmarks