Results 11 to 14 of 14
Thread: detective special problem
-
January 24th, 2012, 01:32 AM #11Member
- Join Date
- Nov 2011
- Location
-
Pittsburgh,
Pennsylvania
(Allegheny County) - Posts
- 50
- Rep Power
- 839
Re: detective special problem
I am not very good at explaining things in detail so I am sorry but I will try to clear this up. When I pull the trigger da the cylinder is not aligned (when it is on one of the 2 "bad chambers" ) and the cylinder can be spun even when the hammer is down and the trigger is held. For sa the cylinder will align but can easily be turned from its barely locked position. Oh and to johnny business, 1 I have been carrying revolvers all weekend and today and 2 you bought your first 3 handguns without picking up a revolver. I was kind of the opposite...
-
January 24th, 2012, 02:01 AM #12Grand Member
- Join Date
- Jan 2008
- Location
-
Henryville,
Pennsylvania
(Monroe County) - Posts
- 3,583
- Rep Power
- 26032
Re: detective special problem
NO ! dont jerk around with it , what you describe is not something for the do it yourselfer, get it to a gunsmith that can work on Colts not many left most have passed away , or go to Colt's website and look into their service packages, they offer many types of repair service, go to the main page then select gunsmith services and contact them by phone , tell them what you want done and they will give you the price over the phone.
Its their gun they know what they are doing they do it every day
-
January 24th, 2012, 11:34 PM #13Member
- Join Date
- Nov 2011
- Location
-
Pittsburgh,
Pennsylvania
(Allegheny County) - Posts
- 50
- Rep Power
- 839
Re: detective special problem
Oh the only way I would do it myself is if it was a direct part swap (also a part that isn't hard to get to) and I've heard once you go past the side plate the colts are different than most other revolvers. I just want to know what I'm getting into before I get charged for someone to look at it. And if it was a matter of replacing the cylinder I may have considered it if I found one but I really don't know at this point
-
January 25th, 2012, 02:14 AM #14Grand Member
- Join Date
- Jan 2008
- Location
-
Henryville,
Pennsylvania
(Monroe County) - Posts
- 3,583
- Rep Power
- 26032
Re: detective special problem
DT, no this is a job for a specialist, more specifically a Colt specialist and most of them are dead, most Smith and Wesson specialist wont even touch a Colt.
As you know Colts cylinder spin the in the right direction while Smiths spin backwards.
Contact Colt and get a price on the job so you know what you are up against, if its quite reasonable i would get it fixed if its too much i would retire it and use it as a conversation piece and left it for the grandkids etc, its been on duty since 1949, its done its job- i think, anyway contact colt.
Similar Threads
-
Colt Detective Special v. S&W Chief's Special
By FCRPhila in forum PistolsReplies: 8Last Post: November 16th, 2010, 10:23 PM -
trade in Detective Special for an LCP?
By BlueGunGuy in forum GeneralReplies: 18Last Post: December 8th, 2009, 01:17 PM -
Colt Detective Special
By knight0334 in forum GeneralReplies: 3Last Post: November 15th, 2007, 02:48 PM
Bookmarks