Results 1 to 4 of 4
Thread: S&W 908s - Re-assembaly question
-
July 24th, 2011, 07:28 PM #1Junior Member
- Join Date
- Feb 2011
- Location
-
Slippery Rock,
Pennsylvania
(Butler County) - Posts
- 12
- Rep Power
- 0
S&W 908s - Re-assembaly question
So I recently purchased a S&W 908s 9mm. It fires dead on and I love it. During my recent cleaning, when removing the slide, I didn't compensate for the slide spring pressure and the slide kind of flung off. The problem is, a little plastic piece came off of the gun and I do not know where this goes. Its purpose, it seems, is to hold the slidestop in place - right now it just kind of sits in its hole, and if the slide is held at the right place, the slidestop will just fall out (as opposed to having to push the slidestop pin pretty hard).
The piece looks like a rolling pin, a cylinder where the two ends are smaller in diameter than the rest. There are also two very tiny circles that say "T" and "3". Can someone please help me put this back where it belongs?
Thanks!Last edited by omniwing; July 24th, 2011 at 08:36 PM.
-
July 24th, 2011, 07:34 PM #2
Re: S&W 908s - I need your help please!
Try posting up some pictures. Also check around online for a schematic for this part you describe.
Join the groups protecting your rights from the fools trying to take them from you!
-
July 24th, 2011, 07:58 PM #3Junior Member
- Join Date
- Feb 2011
- Location
-
Slippery Rock,
Pennsylvania
(Butler County) - Posts
- 12
- Rep Power
- 0
Re: S&W 908s - I need your help please!
Here is the part in the middle, in between a pic of my slide and frame.
-
July 24th, 2011, 09:36 PM #4Junior Member
- Join Date
- Feb 2011
- Location
-
Slippery Rock,
Pennsylvania
(Butler County) - Posts
- 12
- Rep Power
- 0
Re: S&W 908s - Re-assembaly question
I actually figured this out. It sticks out of the slide spring guide, in a little hole. Very phallic.
Anyway, thanks guys!
Similar Threads
-
Smith and Wesson 9mm 908s
By gonzoso in forum GeneralReplies: 1Last Post: October 1st, 2009, 08:42 PM
Bookmarks