original manufacture sbr question.

**BIRTHMACHINE** · June 12th, 2011, 07:53 PM

looking into sbr'ing an hk and i'm a little confused on what to put down as the original manufacture address. am i suppose to but down germany or where it was imported to? do i need to include a street address? all that is ingraved on my gun is city and state of where it's imported to. thanks for any help!

**dc dalton** · June 12th, 2011, 09:14 PM

Originally Posted by BIRTHMACHINE

looking into sbr'ing an hk and i'm a little confused on what to put down as the original manufacture address. am i suppose to but down germany or where it was imported to? do i need to include a street address? all that is ingraved on my gun is city and state of where it's imported to. thanks for any help!

I don't remember an 'original manufacturer address' area on the SBR form and know damn well I didn't put it down when I did my Krinkov cause I don't know his address.

**hooknladder** · June 12th, 2011, 10:14 PM

It is box 4a on a form 1. On mine, it was "D.P.M.S. St. Cloud, MN USA. This is already stamped into the receiver by the manufacturer. You only engrave your name or trust name, city and state. For an imported weapon I would call the atf or email and get it in writing. You wouldn't want your form bounced back and add time to the wait.

**forceinPA** · June 12th, 2011, 10:50 PM

You list who made the reciever, If hk did list them, if it's a vector list them ect. Check out ithinkimamedic's sticky on the SBR process

**BIRTHMACHINE** · June 13th, 2011, 01:13 AM

what is engraved on the reciever is heckler & koch inc, trussville,al. i'm trying to make sure that i don't need to have a complete address, such as a street number.

**BIRTHMACHINE** · June 13th, 2011, 03:00 AM

Originally Posted by dc dalton

I don't remember an 'original manufacturer address' area on the SBR form and know damn well I didn't put it down when I did my Krinkov cause I don't know his address.

thanks smart-ass.

**Noah_Zark** · June 13th, 2011, 07:37 AM

Originally Posted by BIRTHMACHINE

what is engraved on the reciever is heckler & koch inc, trussville,al. i'm trying to make sure that i don't need to have a complete address, such as a street number.

That's all you need.

Don't worry about a street address.

Noah

**forceinPA** · June 13th, 2011, 02:25 PM

NO, If this is a form1 you will engrave your name and city, state, not HK's. What ever reciever your using should all ready be engraved with the manufacture. Unless your machining the complete reciever from scratch.