Results 1 to 4 of 4
Thread: Glock recoil spring
-
March 8th, 2011, 06:59 PM #1
Glock recoil spring
On the front barrel lockup point where the spring sits, there are 2 notches. the front one is right up against the barrel and rounded to match the guide rod.
My question is this.....everytime I put my gun together I put the spring on the rounded one....every time I take it apart it has slipped up one notch....is this normal? Does it happen when I pull down the takedown buttons? Could the guide rod be moving while Im shooting?
-
March 8th, 2011, 07:19 PM #2
Re: Glock recoil spring
Normal.
When you reassemble, the recoil spring assembly comes off that rounded ledge of the front of the barrel's unlocking lug and rests inside the dust cover area, in front of/against the locking block. That semi-circle is just a reference point for correct alignment during reassembly.
Regards,
Bones
-
March 8th, 2011, 07:41 PM #3
Re: Glock recoil spring
Like mentioned this is normal
-
March 9th, 2011, 12:06 AM #4
Re: Glock recoil spring
Ok, thanks
Similar Threads
-
Glock recoil spring
By dinosaur in forum PistolsReplies: 10Last Post: March 4th, 2011, 01:29 PM -
Glock Recoil Spring Problem?
By Nic in forum GeneralReplies: 5Last Post: November 9th, 2009, 09:04 AM -
sr9 recoil spring
By Papuppyowner in forum GeneralReplies: 4Last Post: July 29th, 2009, 08:34 PM -
H&K recoil spring
By randyreload in forum GeneralReplies: 3Last Post: February 1st, 2009, 04:57 AM -
H&K recoil spring
By randyreload in forum GeneralReplies: 0Last Post: January 31st, 2009, 10:46 PM
Bookmarks