SBR Engraving.

[Strgthnabilty]

Since the last thread turned into like a huge argument. I am in the process of making an SBR out of a lower that I have had for some time now. I need to have it engraved and would like this to happen quickly. I live in the Allentown area and would like if I didnt have to send it out some where through an FFL. The cheaper the better!

[JayBell]

Since the last thread turned into like a huge argument. I am in the process of making an SBR out of a lower that I have had for some time now. I need to have it engraved and would like this to happen quickly. I live in the Allentown area and would like if I didnt have to send it out some where through an FFL. The cheaper the better!

check your local yellow pages for Trophy shops that can engrave while you wait.

[Strgthnabilty]

I was told that it needs to be done with a laser, and certain specs must be met. I would much rather have someone do it that has done it before. Much rather then wishing someone the best of luck. I mean its almost like going to the bank and asking them to fix my car!

[GUNGUY45]

I was told that it needs to be done with a laser,(Can be done with stamps, or a Dremel, or whatever...) and certain specs must be met.(serial number must be .003 deep, and 1/8" in height, min, other markings???I'd use the same, but that's me) I would much rather have someone do it that has done it before.( good Idea, Aluminum recievers can be hard anodized, if someone tries with a high speed steel bit it could be trouble. Carbide cutters are best.) Much rather then wishing someone the best of luck. I mean its almost like going to the bank and asking them to fix my car!

My thoughts are in red.

[smit308]

Donley's Gun Shop in Quakertown did mine and did a fine job. Low price if I remember correctly. Give him a call.

http://www.gunrunner1000.com/index.htm

[arrrrgh15]

I had orion arms do mine years ago. I sent him an image to engrave on the side of the mag well as well. i was told the hard anodizing of the receiver can chip with engravers. I saw some photos of some guys receiver he had a pimple faced kid at the gift shop in the mall engrave and it looked like complete shit.

[Toxicodendron11]

Donley's Gun Shop in Quakertown did mine and did a fine job. Low price if I remember correctly. Give him a call.

http://www.gunrunner1000.com/index.htm

+1 on Donelly's. He is engraving a lower for me, as we speak. Cost:$75

[MD66948]

+1 on Donelly's. He is engraving a lower for me, as we speak. Cost:$75

Make sure you tell him to blacken the engraving. Make sure it is marked on your receipt. He doesn't always do it even when specified.

[Toxicodendron11]

Make sure you tell him to blacken the engraving. Make sure it is marked on your receipt. He doesn't always do it even when specified.

Duly noted but already addressed.

[Fensemaus]

Please let us know how it turns out. I'd like to use Donelly's also, but I'm concerned about the anodizing chipping.

I know Orion Arms and Ident do nice work, but I'd rather not deal with the hassle of mailing out of state.