Results 1 to 7 of 7
Thread: WASR 10 muzzle brake question.
-
November 20th, 2010, 10:57 AM #1
WASR 10 muzzle brake question.
I have a wasr10, and I purchased a tapco slant muzzle brake. My question is, when I thread it onto the barrel does the muzzle end have to sit flush with the lip in the brake? The brake has a lip in the middle of the inside. I can get it on tight but has about a 3/8inch gap between the muzzle and the lip.
-
November 22nd, 2010, 04:47 PM #2
Re: WASR 10 muzzle brake question.
HUH?
The front sight block should have a tensioning rod that snaps into a groove in the muzzle brake. It doesn't get cranked on, it's supposed to sit at a slight angle, and they are almost never "tight". Are you talking about a gap between the front sight block and the brake? Or the end of the muzzle itself and the inside of the brake? Or the tensioning (detent) rod on the front sight block and the groove in the brake?
-
November 23rd, 2010, 08:56 AM #3
Re: WASR 10 muzzle brake question.
[QUOTE=Asmodeus6;1407122]HUH?
Or the end of the muzzle itself and the inside of the brake? QUOTE]
This one. Did I confuse you alittle?
-
November 23rd, 2010, 12:17 PM #4
Re: WASR 10 muzzle brake question.
A picture or drawing would help, but if you have it threaded on the entire way then you did it right.
In America arms are free merchandise such that anyone who has the capital may make their houses into armories and their gardens into parks of artillery. - Ira Allen, 1796
-
November 23rd, 2010, 12:31 PM #5Banned
- Join Date
- Jul 2010
- Location
-
Kennet Square,
Pennsylvania
(Chester County) - Age
- 48
- Posts
- 649
- Rep Power
- 0
Re: WASR 10 muzzle brake question.
I just went and looked at my wasr 10. It has a factory installed slant brake and it appears that it is flush on the outside but not exactly flush on the inside as there are a few threads showing on the inside. As long as it is on a slant and locked into the push pin, i would say your good to go. I only have a crappy cell phone for pics at the moment so here are some pics i took that maybe slightly helpful, granted i couldnt get a great pic of the inside.
Uploaded with ImageShack.us
Uploaded with ImageShack.us
-
November 23rd, 2010, 02:43 PM #6
-
November 23rd, 2010, 03:33 PM #7
Re: WASR 10 muzzle brake question.
Thank you everyone. Gonna head to the range and see how it works.
Similar Threads
-
Muzzle brake question
By Wayne in forum GeneralReplies: 2Last Post: November 9th, 2009, 01:08 PM -
how tight for a muzzle brake
By 97grnrs in forum GeneralReplies: 6Last Post: June 23rd, 2009, 03:54 AM -
Muzzle Brake
By pistoffjstr in forum GeneralReplies: 11Last Post: October 2nd, 2008, 06:24 PM -
muzzle brake
By sparkz in forum GeneralReplies: 4Last Post: May 27th, 2008, 06:33 AM -
AK Muzzle brake
By Justin in forum GeneralReplies: 3Last Post: May 16th, 2007, 09:47 PM
Bookmarks