H&R 929 Hammer Mounted Firing Pin

**irongreek** · November 15th, 2010, 09:59 AM

The tip of my H&R 929 (circa 1956) hammer-mounted firing pin broke off, so of course, now it does not fire. Does anyone know a gunsmith that could repair/replace the thing? I noted that Numrich gun parts company only provided a schematic of the newer models with separate firing pins, so I haven't found any gun parts companies that might have any. I'm in Carlisle, PA. Thanks for any help!

***Klutch*** · November 15th, 2010, 10:06 AM

Give this guy a call:
Felker Firearms & Gunsmithing
208 LeFevre Rd
unit 2
Stockertown, PA 18083
610-365-2859
His name is Nick he should be able to help.

**32 Magnum** · November 15th, 2010, 02:26 PM

If you decide to get a new hammer - this is the part you need (from Numrich):

http://www.gunpartscorp.com/catalog/...10B&catid=7927

**irongreek** · November 16th, 2010, 09:09 AM

Thanks for the reply. I checked out the part, and wonder if the hammer will work, since it says "All series U and on," and my serial number starts with an S.

**32 Magnum** · November 16th, 2010, 04:35 PM

iron - Model 929 first showed in the catalogues in 1957 (T) - As far as I can see the hammer shape didn't change until the 2nd Issue pieces with the transfer bar ignition/safety system. Check the picture - does your hammer look like the one on my 1958 (U)? If so you should be good to go with the Numrich hammer.
IMG_1457_2.jpg IMG_1460.jpg