Results 1 to 10 of 24
Thread: Glock Conversion From .40 to 9mm
-
October 13th, 2010, 05:03 PM #1
Glock Conversion From .40 to 9mm
Ok, I've been discussing it in a bunch of other threads, I figured I'd start a new one to get some clear answers. I have a Glock 27. I'd like to convert it to 9mm at some point. Do I need an aftermarket barrel? Or could I use a factory Glock 26 barrel? Also, should I replace the extractor and ejector?
Any body have any experience with this?Selling off a a sizeable Spyderco collection here
-
October 13th, 2010, 05:12 PM #2
Re: Glock Conversion From .40 to 9mm
Glock website shows that the barrels from both the G26 and G27 have the same height and width measurements.
Here is a link to The firedragon conversion:
http://www.efkfiredragon.com/proddet...rod=GK27339SBC
-
October 13th, 2010, 05:15 PM #3Senior Member
- Join Date
- Jan 2010
- Location
-
BOWMANSVILLE,
Pennsylvania
(Lancaster County) - Posts
- 290
- Rep Power
- 2255
Re: Glock Conversion From .40 to 9mm
CHECK OUT- "GLOCKTALK.COM =- Your question has been asked & answered there i believe several times. this will save you a lot of time in obtaining a correct answer!!!!!!
-
October 13th, 2010, 05:28 PM #4
Re: Glock Conversion From .40 to 9mm
Your .40cal (23/22) will require a conversion barrel because the OD of the barrel is larger than the 9mm counterparts.
I highly recommend changing the ejector block. It's a <$10 part. It will eject more reliably in my personal experiences converting several 23's and 22's to 9mm._________________________________________
danbus wrote: ...Like I said before, I open carry because you don't, I fight for all my rights because
you won't, I will not sit with my thumb up my bum and complain, because you will.
-
October 13th, 2010, 06:29 PM #5
-
October 13th, 2010, 07:26 PM #6
-
October 13th, 2010, 07:33 PM #7Banned
- Join Date
- Oct 2010
- Location
-
Too Close To Chester,
Pennsylvania
(Delaware County) - Posts
- 10
- Rep Power
- 0
Re: Glock Conversion From .40 to 9mm
Can I ask why you would want to do this? If you were talking about a .22 conversion, I might be able to understand it from a training perspective, but a .40 to a 9mm doesn't seem to make any sense. I'm sure you have a good reason. Could you explain?
-
October 13th, 2010, 07:39 PM #8
-
October 13th, 2010, 08:01 PM #9
Re: Glock Conversion From .40 to 9mm
Selling off a a sizeable Spyderco collection here
-
October 14th, 2010, 10:55 AM #10Grand Member
- Join Date
- Jan 2007
- Location
-
OUT TO LUNCH
- Posts
- 4,574
- Rep Power
- 21474858
Similar Threads
-
Glock .50 cal conversion
By RONNIE77 in forum GeneralReplies: 9Last Post: April 22nd, 2011, 02:50 AM -
.22 conversion kit for Glock 22
By Glock22xd9 in forum GeneralReplies: 8Last Post: December 12th, 2006, 12:04 AM
Bookmarks