Post your AR with pictures here!

[chrmm22sr]

My build on a Black rain ordnance lower

[Gunowner99]

Those are some nice AR;s.

[Splittiebus66]

[partsman]

Just ran this guy through its paces at the range today. Painted it day before yesterday - adding a little bit of diversity to the collection.

11.5" Dan Def upper, AAC Brakeout & 762sdn-6, Aimpoint T-1, Troy BUIS, Magpul goodies, Krylon paint job.





and make sure you don't mess with tactical kittie.

im am looking at building one like this how long was the wait for stamp ?

[ShelbyGoat]

im am looking at building one like this how long was the wait for stamp ?

right now about 6-7 months

[MrBear13]

Left DPMS A15; Right Bushmaster XM15 E2S

I'm going to paint the DPMS, possibly today if I grow a pair. Should I lay down a primer first or is it not really necessary? I found a deal on a receiver and PMags (yesterday, http://forum.pafoa.org/general-2/197...ml#post2457395) and was going to order them today and I didn't. I did, however, buy the Bushmaster yesterday. Probably should have just bought an Aimpoint for the DPMS instead of the junk on it now. Anyway, I'm looking for a lower that I find interesting and unique and am going to start my first build, either a 20" heavy barrel or a 10.5" pistol. Decisions, decisions...

[Splittiebus66]

Primer isnt necessary unless you have exposed metal.

[Solaran_X]

Colt M4 LE6920
- EOTech 552
- EOTech G33.STS
- Troy BattleRail Charlie
- PWS FSC556
- Midwest Industries Upper Height Gas Block
- Spike's Tactical 12" Havoc Launcher
- Magpul ACS Stock
- Magpul MOE+ Grip
- Magpul MS3 Sling
- Magpul RSA (not seen, on other side of rail)
- Magpul A.S.A.P.
- Magpul Front MBUIS
- Magpul Rear MBUIS
- Magpul B.A.D. Lever
- Magpul PMAG 2nd Generation Windowed (12)
- 37mm skybanger rounds (5)
- 37mm smoke round
- My ACU shooting jacket with all my appropriate Navy stuff on it (ship patch, ESWS pin, PO3 rank badge and the original Navy jack in addition to a reverse flag and Gadsden flag)

I think that just about covers everything. All I really have left to do with it is get it it's own optics again (the 552 and G33.STS are off my KRISS Vector for this picture, looking at a 512 and G33.STS for this rifle), a Geissele SSA-E trigger and those metal Magpul MBUIS PRO once they're released. And considering upgrading to a Magpul MS4 QD sling and the Magpul QD RSA. I could love for Magpul to release a QD ASAP. And I'll get the 40 round PMAGs if they make a windowed version.

And once I set up my gun trust; I'll be SBRing this rifle, adding a suppressor (most likely an AAC M4-2000) and reclassifying the 37mm as a Destructive Device.

[MrBear13]

Primer isnt necessary unless you have exposed metal.

Didn't think so but wasn't sure, thank you very much.

[Gunowner99]

That's some set-up!!