|
|||||||
 |
|
|
Thread Tools | Display Modes |
September 27th, 2009
|
||||
|
||||
AR-15 Need some gunsmithing help local area
bought a Larue Free floating rail for my ar-15 and I have to remove the FSB to install it and don't have the proper tools, vise etc to get er done...I was hoping somebody could help me out or lead in the right direction,,,,
sabotage_02@yahoo.com is the best way to reach me!!!!! 
|
|
|
September 28th, 2009
|
||||
|
||||
|
Re: AR-15 Need some gunsmithing help local area
gunrunner 1000.com
Dave is awsome and is located in quakertown.
|
|
September 28th, 2009
|
||||
|
||||
|
Re: AR-15 Need some gunsmithing help local area
To remove the FSB, all you need is a roll pin punch (you can get a set for $20 at Lowe's) and a hammer. Just make sure you punch from left to right (left when muzzle forward in the same direction that you're facing). Don't know much about installing the Larue though, but FF rails are usually very easy to install.
Al
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Local Refinishing - Butler Co Area | Too-Tall | Pistols | 9 | September 25th, 2009 01:25 AM |
| Ron's Gunsmithing | MTechnik | Gunsmiths | 0 | March 9th, 2009 10:47 PM |
| Gunsmithing in PA | mick | Gunsmithing | 6 | November 6th, 2007 09:54 PM |
| Minor Gunsmithing needed in BuxMont area. | AftonJohnny | Gunsmithing | 3 | July 19th, 2007 10:19 AM |
| Gunsmithing course | 91xlt | Gunsmithing | 8 | December 22nd, 2006 06:00 PM |
All times are GMT -5. The time now is 09:25 PM.