- Tab Content
- ckeller's Activity
- About Me
- Friends
-
Older Activity
-
March 28th, 2024, 06:28 PMhttps://www.reddit.com/r/ak47/comments/1bcg8tt/update_on_barnaul_762x39_spam_cans/ sounds like it fits the bill of as a middle man doing the drop...3 replies | 115 view(s)
-
March 17th, 2024, 10:51 AMscoutjoe replied to a thread Can I buy dinner and drinks to teach me about 3d printing Glock lowers? in GeneralTrinkets and do-dads seem to be print and go. Anything that has specific tolerances can and will likely need some work. The amount of tweaking...14 replies | 531 view(s)
-
March 16th, 2024, 09:26 AMscoutjoe replied to a thread Harrisburg, PA Gunshow March 23 & 24 @ PA Farm Show Complex in Gun ShowsSo $13 at the door and $10 to park, unless I've missed something.34 replies | 1537 view(s)
-
March 3rd, 2024, 11:01 AMI've ran the self test and the diagnostic. The print quality comes out great just a little too small. The last print at 105% is real close to...83 replies | 10994 view(s)
-
March 2nd, 2024, 10:35 AMI actually went up to an X1 Carbon. It almost feels like cheating after tinkering around with the Ender.83 replies | 10994 view(s)
-
March 1st, 2024, 10:35 PMSo I feel like I'm missing a setting somewhere but my prints are not correct on the x/y dimension. A 20 mm calibration cube is coming up around 19.8...83 replies | 10994 view(s)
About ckeller
Basic Information
- Age
- 36
Location Information
- City:
- Ebensburg
- State:
- Pennsylvania
- County:
- Cambria
Statistics
Total Posts
- Total Posts
- 59
- Posts Per Day
- 0.01
General Information
- Last Activity
- March 3rd, 2009 12:34 PM
- Join Date
- February 12th, 2009
- Referrals
- 0