Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Bang
Grand Member

Mini Statistics

Join Date: February 16th, 2010

Last Activity: September 19th, 2024 03:32 PM

More 2 Friends

Tab Content: Bang's Activity; About Me; Friends

Tab Content: All; Bang; Friends; Photos

Older Activity
September 19th, 2024, 03:20 PM

Bang replied to a thread Trigger Job in Gunsmithing

If a blow-down burst shell ever occurs, that open stylized grip is going to add to the potential for injury... like a guarantee.

see more

15 replies | 470 view(s)
September 10th, 2024, 08:17 PM

Bang replied to a thread Coyote Hunting questions? in Hunting

Give Russia, China and Iran a little more time and thermal stuff will get scarce and high.

see more

5 replies | 215 view(s)
September 2nd, 2024, 05:56 PM

Bang replied to a thread Scumbag who shot Trump thread in General

Gun was purchased by the father something like 12 years ago. The official who stated the collapsible stock helped hide the rifle in the knapsack was...

see more

73 replies | 25171 view(s)
September 2nd, 2024, 05:51 PM

Bang replied to a thread AR15 charging handle not locking bolt back in Gunsmithing

Sounds like a simple fix. File (or stone,if too hardened) the flat that slips into the "grab receiver" mode. If it fits other guns, I'd suspect...

see more

6 replies | 243 view(s)
August 28th, 2024, 02:33 PM

Bang replied to a thread Question on jframe trigger issue in Gunsmithing

Timing is exactly what became the problem with my Colt Detective Special purchased (and carried since) 1961. The original timing problem was cured by...

see more

21 replies | 1254 view(s)
August 28th, 2024, 11:35 AM

Bang replied to a thread Slide locking back in Training, Tactics & Competition

Just a wag: Difference in recoil absorption. She with lighter body construction vs your heavier frame combined with a too-light retention spring on...

see more

9 replies | 721 view(s)
August 26th, 2024, 03:58 PM

Bang replied to a thread Reading to vote to Ban "Ghost Guns" in Pennsylvania

Marlin 80-DL (.22 bolt action rifle) purchased for me by Dad in 1950. No serial number. From what I have seen, lower end rifles and shotguns prior to...

see more

29 replies | 1806 view(s)
August 21st, 2024, 12:03 PM

Bang replied to a thread Bump Stock Ban ruled illegal in National

Trying to imagine the personnel assigned, storage space, record generation/keeping, portion of cost to taxpayers...all that stuff, doing .00000001...

see more

28 replies | 2116 view(s)
August 21st, 2024, 11:55 AM

Bang replied to a thread Question on jframe trigger issue in Gunsmithing

The factory personnel do not know you. They do know that people can be less than honest, especially when trying to get a service not deserved. The...

see more

21 replies | 1254 view(s)

No More Results

About Bang

Basic Information

Location Information

City:: Levittown

State:: Pennsylvania

County:: Bucks

Signature

There are two kinds of guns. Those I have acquired, and those I hope to.

Statistics

Total Posts

Total Posts: 9,711

Posts Per Day: 1.82

General Information

Last Activity: September 19th, 2024 03:32 PM

Join Date: February 16th, 2010

Referrals: 1

2 Friends

donotknowme

Grand Member
steelerfan

Grand Member

Showing Friends 1 to 2 of 2

All times are GMT -4. The time now is 10:15 AM.

Bang Grand Member