AR help in Lancaster County

**jtkratzer** · April 17th, 2015, 10:41 PM

I have a BCM mid length en route and I'm looking to remove the A2/M4 hand guards and replace them with an M-Lok free float and then reinstall the FSB. I don't have the tools to work on the barrel nut and no experience working on uppers. Depending on the staking on the castle nut, I'd also like to replace the lower end plate with one that has a sling QD mount. I lack the clamshell block to put the receiver in a vise and a barrel nut wrench. I'd appreciate the help and can do a few beers afterward.

**bripro** · May 24th, 2015, 09:09 AM

I know its been over a month since you posted but I just saw it. If you are still in need of the tools let me know via pm. I have everything you should need, a good work area and some experience with it to boot.

**jim-analog** · May 31st, 2015, 04:03 PM

Greetings,

The first reply from Bripro is in your area, but if you get stuck and want to drive out to Upper Bucks, I'd be glad to help and have all the tools as well. Good luck with your project!

Regards, Jim

**jtkratzer** · June 4th, 2015, 11:48 AM

Thanks for the replies. I got it done before a trip to Africa. I bought the Tapco wrench, upper receiver vise block, and borrowed some space on a buddy's workbench and vise.